5
BEFORE OPERATION
Your oven has an energy save mode.
1.
Plug in the oven. Nothing will appear on the display at this time.
2.
Open the door, the display will flash the message shown opposite.
3.
Close the door. The display wil show “.0”. If you set the
clock “energy save” mode will be off. If you keep “energy
save” mode, go to step 5.
4.
Set the clock, refer to page 6.
5.
Heat the oven using the upper and lower grills without food
for 20 minutes. (For operation, see NOTES on page 10).
Use the
STOP/CLEAR
key to:
1.
Erase a mistake during programming.
2.
Stop the oven temporarily during cooking.
STOP/
CLEAR
STOP/CLEAR
key
INSTALLATION (CONTINUED)
BUILDING-IN-KIT
An installation frame is available which enables the
microwave oven to be integrated within a kitchen unit.
The microwave oven is not designed to be built above
or near a conventional oven.
SHARP recommend the use of the build in kit,
EBR-4600
, available from your SHARP dealer. Only
the use of this frame will guarantee the quality and
safety of the oven. When building, follow installation
instructions supplied carefully.
IMPORTANT! ELECTRICAL CONNECTION
• Do not allow water to come into contact with the
power supply cord or plug.
• Insert the plug properly into the socket as the plug
may otherwise overheat and catch fire.
• Do not connect other appliances to the same socket
using an adaptor plug as it may cause the house
wiring to overheat and catch fire.
• If the plug or socket is loose or the power supply
cord is damaged, it must be replaced with a
special cord. The exchange must be made by an
authorised SHARP service agent.
A defective plug, power supply cord or socket may
overheat and catch fire during operation or cause
an electrical shock.
• When removing the plug from the socket always
grip the plug, never the mains lead as this may
damage the power supply cord and the
connections inside the plug.
• The product is fitted with a re-wireable plug. Should
it not be suitable for the socket outlet in your home,
remove the plug and fit an appropriate type,
observing the wiring code on page 60.
If you wish to remove or replace the plug supplied,
ensure the plug is removed properly and not cut off.
When replacing the plug please ensure that you use a
BSI or ASTA approved plug to BS1363, this should be
fitted with a brown coloured 13 amp fuse approved
by BSI or ASTA to BS1362. If you have any doubt
about electrical connection seek the help of a
qualified electrician.
WARNING - IMPORTANT NOTE
Please note both the Operation Manual and Cookery
Book supplied specify 900 W (IEC 705) microwave
output power. This applies only when the oven is
operated on a 230-240V supply.
If your supply is less than 230-240V, it may be
necessary to increase the cooking time when
following the Operation Manual and Cookery Book
instructions.
THIS APPLIANCE MUST BE EARTHED
To wire an appropriate plug, follow the
wiring code on page 60.
WARNING:
Summary of Contents for R-772M
Page 2: ......
Page 65: ...63 NOTES ENGLISH ...
