E – 3
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity , (do not remove the waveguide cover), and the
feature sticker from the outside of the door, if there is one. Check the unit for any damage, such as a
misaligned door, damaged door seals around the door or dents inside the oven cavity or on the door.
If there is any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE
APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1) Turntable
2) Roller Stay
3) Rack
4) Operation manual
5) Cookbook
3. Since the door may become hot during cooking, and in order to avoid its accidental touch, the oven
should be placed at least 80 cm or more above fl oor. You should also keep children away from the door
to prevent them burning themselves.
4. Place the roller stay in the coupling on the oven fl oor, then place the turntable on to the roller stay,
ensuring it is located fi rmly. Refer to OVEN DIAGRAM on page E-4. NEVER operate the oven without the
roller stay and turntable.
5. This oven is designed to be used on a countertop only. It should not be installed in any area where
excessive heat and steam are generated, for example, next to a conventional oven unit.
The oven should be installed so as not to block ventilation openings.
Allow space of at least 40cm from top of the oven for air ventilation.
This oven is not designed to be built-in to a wall or cabinet.
6. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage and frequency must correspond to the one indicated on the rating label at the back of
the oven.
7. This appliance must be earthed:
IMPORTANT
The wires in power supply cord are coloured in accordance with the following code:
Green-and-yellow : Earth
Blue
: Neutral
Brown
: Live
As the colours of the wires in the power supply cord of this appliance may not correspond with the
coloured marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured blue.
The wire which is coloured brown must be connected to the terminal which is marked with the letter
L or coloured brown.
R-667R(S) [01 EN].indd 3
R-667R(S) [01 EN].indd 3
1/15/10 4:11:32 PM
1/15/10 4:11:32 PM
