Sharp PG-M10SE, Service Manual

Page: 13 / 31

13
PG-M10SU/SE
PG-M10XU/XE
11)Projection lens (See Fig. 11.)
Remove the three screws (S-7) shown in Fig. 11,
and detach the projection lens.
Note: When reassembling, be careful not to damage
the spherical mirror inside of the lens base.
Projection lens
S-7
S-7
Fig. 11
Fig. 12
12)Color wheel (See Figs. 12 and 13.)
Remove the two screws (S-9) shown in Fig. 12, and
detach the color wheel from the lens base.
Remove the two screws (S-4) shown in Fig. 13, and
detach the wheel cover from the color wheel.
Remove the wheel screw shown in Fig. 13, and
detach the wheel sensor.
Note: When reassembling, be careful not to tighten
the screws too much. Otherwise the color wheel
mat come in contact with other components
nearby and fail to rotate. Readjustment will be
needed if the color wheel and the wheel sensor
have been replaced. (Refer to page __.)
Color wheel
S-9
S-9
Fig. 13
Wheel Cover
Wheel Sensor
S-4
13)Light tunnel and aperture (See Fig. 14.)
Remove the three screws (S-7) shown in Fig. 14,
and detach the light tunnel from the lens base.
Remove the two screws (S-4) shown in Fig. 14, and
detach the aperture from the lens base.
Note: Do not disassemble the light tunnel.
Fig. 14
Light Tunnel
Aperture
S-4
S-7
S-7