Sharp PG-M10SE, Service Manual

Page: 11 / 31

11
PG-M10SU/SE
PG-M10XU/XE
3) Speaker, buttons, etc. (See Fig. 3.)
As shown in Fig. 3, remove the nuts, speaker button
OP, and LED lens. Undo the hooks and remove
front buttons.
5) Disassembling the front panel (See Fig. 5.)
Remove the screw (S-12) shown in Fig. 5, and
detach the front door.
Remove the screw (S-4) and take out the IR PWB.
Remove the two screws (S-1) and detach the plates.
Remove the screw (S-4) each off the right and left
front hooks, and detach the hooks.
Fig. 5
Front Door
S-4
S-4
S-1
S-12
S-18
S-4
Top Cover
Front Foot
LED
Lens
Speaker Ass’y
Button
OP
S-25
S-25
Fig. 3
4) Insulation barrier, urethane foam shield, etc. (See
Fig. 4.)
As shown in Fig. 4, the front cabinet is lined with
the barrier sheet.
Top Cover
Fig. 4
6) F/E PWB (See Fig. 6.)
Remove the screw (S-13) and two screws (S-5)
shown in Fig. 6, and disconnect the connectors.
Remove the screw (S-13) and two RGB spacers,
and detach the connector panel.
F/E PWB
RGB Spacer
Connector
Panel
S-23
S-5
S-13
S-5
S-13
S-23
S-23
Fig. 6