MX-7000N MX-LCX3 3 – 11
(2) Mechanical adjustment-1
Since the off-center adjustment has been made at shipping, there
is normally no need to adjust. If the center is shifted, however,
adjust with the simulation. If the shift is not recovered, perform the
following steps to adjust.
<1>
Slowly pull out the paper feed base tray until it stops.
[When shifted to the front side]
When shifting the line of printing from the center of the paper in the
direction A of arrow as shown below:
<2>
Loosen the blue off-center adjustment screws (each 2 pcs.), and
move the side plate by the dimension shifted in the direction A (R
side), and tighten the loosened blue screws.
NOTE: Move the side plates by the same dimension on the front
side and the rear side.
<3>
Push the large capacity tray slowly into the original position.
Then make a copy again to check to insure that there is no more
shifet. Repeat this procedure as required.
[When shifted to the rear side]
When shifting the line of printing from the center of the paper in the
B direction of arrow as shown below:
<2>
Loosen the blue off-center adjustment screws (each 2 pcs.), and
move the side plate by the dimension shifted in the direction B (F
side), and tighten the loosened blue screws.
NOTE: Move the side plates by the same dimension on the front
side and the rear side.
