SPEC No.
LD-28204A
MODEL No.
LS013B7DH07
PAGE
8
[Other Notice]
(1) Operation outside specified environmental conditions cannot be guaranteed.
(2) As power supply (VDD-GND
、
VDDA-GND) impedance is lowered during use, bus controller should be
inserted near LCD module as much as possible.
(3) Polarizer is applied over LCD panel surface. Liquid crystal inside LCD panel deteriorates with ultraviolet
ray. The panel should not be left in direct sun or under strong ultraviolet ray for prolonged period of time
even with the polarizer.
(4) Disassembling the LCD module will cause permanent damage to the module. Do not disassemble the
module.
(5) If LCD panel is broken, do not ingest the liquid crystal from the broken panel. If hand, leg or clothes
come in contact with liquid crystal, wash off immediately with soap. If mouth or eyes come in contact with
liquid crystal, rinse with water as soon as possible, following the instructions of the appropriate MSDS.
(6) ODS (specific chlorofuorocarbon, specific halon, 1-1-1 trichloroethane, carbon tetrachloride) are not used
or contained in material or all production processes of this product.
(7) Observe all other precautionary requirements in handling general electronic components.
Discarding liquid crystal modules
Follow the regulations when LCD module is scrapped. The government you stay may have some regulations
about it.
LCD Panel
: Dispose of as glass waste. This LCD module contains no harmful
substances.
The liquid crystal panel contains no dangerous or harmful substances.
This liquid crystal panel contains only an extremely small amount of liquid
crystal (approximately 100mg) and therefore it will not leak even if the
panel should break.
Its median lethal dose (LD50) is greater than 2,000 mg/kg and a
mutagenetic (Aims test: negative) material is used.
SHARP Confidential
technical
literature
©Copyright 2016 SHARP All rights reserved
©Copyright 2016 SHARP All rights reserved
Summary of Contents for LS013B7DH07
Page 1: ......
