Sharp LC-37XD10, Service Manual

Page: 23 / 190

LC-37XD10E/RU
3 – 6
15.If the Flash has burned successfully, "OK" message is shown as
below.
16.Turn the AC power off , and turn AC power on.
Return to default automatically.
17.Finish!!
18.Prepare for next model
If you have once write the software to the set, the PC side commu-
nication speed will be set up to "115200".
So before you connect the PC to the next set, please change back
this speed to "9600".
(Please refer 4-(i)-2)
19.Software writing time
It takes about 15 minutes to write the all software with above
method.
Please keep the cable connection during the PC and Set having a
communication.
3. Entering and exiting the adjustment process mode
1 Unplug the AC power cord of running TV set to force off the power.
2 While holding down the “VOL (-)”and” MENU ” keys on the set at once, Press the "POWER"key on the se t
to turn on the power. The letter appears on the screen.
3 Next, hold down the “VOL(-)”and
㵘
”P( )” keys on the set at once.
Multiple lines of orange characters appearing on the screen indicate that the set is now in the
adjustment Process mode. If you fail to enter the adjustment process mode (the display is the same as
normal startup), retry the procedure.
4 To exit the adjustment process mode after the adjustment is done, unplug the AC power cord to force off
the power. (When the power is turned off with the remote controller, once unplug the AC power cord and
plug it in again. In this case, wait 10 seconds or so before plugging.)
5 To remove "K" mode, just repeat step1 and 2. This time the letter "K" disappears from screen.
Caution: Use due care in handling the information described here lest the users should
know how to enter the adjustment process mode. If the settings are tampered
with in this mode, unrecoverable system damage may result.
K
(Alternative)
1) Press the "MENU" key on the set, and OSD appears.
2) Move the cursor to SERVICE(OSD) using the cursor keys on the remote controller.
When pressing the "MENU" key on the remote controller, the set enters the adjustment process mode.