LC-24LE170I
10 – 1
CHAPTER 10.
SCHEMATIC DIAGRAM
[1] DESCRIPTION OF SCHEMATIC DIAGRAM
1. VOLTAGE MEASUREMENT CONDITION:
1) The voltages at test points are measured on exclusive AC adaptor
and the stable supply voltage of A C 110-240V . Signals are fed by a colour bar signal
generator for servicing purpose and the above volt ages are measured with a 20k ohm/V tester .
2. INDICATION OF RESISTOR & CAPACITOR:
RESISTOR
1) T he unit of resistance " " is omitted.
(K=k =10 00 , M=M ).
2) All resistors a re ± 5%, un less otherwise noted.
(K= ± 10 %, F= ± 1% , D= ± 0.5%)
3) All resistors are 1/16W , unless otherwise noted.
C APACITOR
1) All capacitors are F, unless otherwise noted.
(P=pF = F) .
2) All capacitors are 50V, unless otherwise noted.
CAUTION:
This circuit diagram is original one , therefore there may be a sl ight
difference from yours.
SAFETY NOTES:
1) DISCONNECT THE AC PLUG FROM THE AC OUTLET
BEFORE REPLACING PART S.
2) SEMICONDUCTOR HEA T SINKS SHOULD BE REGARDED AS
POTENTIAL SHOCK HAZARDS WHEN THE CHASSIS IS
OPERATING .
IMPORTANT SAFETY NOTICE:
PAR TS MARKED WITH "
" (
) ARE IMPORTANT
FO R MAINTAINING THE SAFETY OF THE SET . BE SURE TO
REPLACE THESE PARTS WITH SPECIFIED ONES FOR MAIN-
TAINING THE SAFETY AND PERFO RMANCE OF T HE S ET.
