19
GB
Operating a TV Using the
Remote Control
(Universal Remote Control)
The Universal Remote Control may operate the
basic functions of 16 different types of TVs.
To enter the Manufacturer’s Code for your TV,
follow the instructions below.
There is no guarantee that the universal
remote control will function with your TV.
Setting the
Manufacturer’s Code
1
Press
OPERATE
and
CH
'
of
TV CONTROL
simultaneously.
2
Enter the 2-digit Manufacturer’s
Code with the
Number
buttons
(Ex. 02-“0”, “2”) within 10
seconds after releasing
OPER-
ATE
and
CH
'
of TV CON-
TROL
.
3
Point the remote control unit
towards the TV and then press
OPERATE of TV CONTROL
.
• If the TV turns on/off, setup was
successful. If not, repeat the proce-
dure using another code.
See the list below for the Manufacturer’s Code
and the buttons which work.
Major Components
Setting the Remote
Control Code
• Two types of remote control codes operate
this Recorder: RC-1 and RC-2. If you
operate this Recorder by remote control
along with another SHARP DVD recorder or
DVD player placed next to it simulta-
neously, switching the remote control code
(both the Recorder and remote control) to
one of the signals (RC-1 or RC-2) will let
you operate only with this Recorder.
• Make sure to set the Recorder and remote
control to the same remote code. You can
not operate the Recorder if they are not set
to the same code.
Setting the Remote Con-
trol Code of the Remote
Example:
Setting the code to “RC-2”.
1
Press and hold
OPERATE
and
2
together for more than 5 seconds.
2
Press
OPERATE
of this Recorder
to see if you can turn it on/off.
• If you cannot, go to step
3
.
NOTE
• The remote control code of the remote
becomes “RC-1” when you change the
batteries.
Setting the Remote Con-
trol Code of the Recorder
3
Press
OPERATE
to turn off the
Recorder.
4
Press and hold
CHANNEL
"
and
CHANNEL
'
on the Recorder
together for more than 5 seconds.
• Each time this operation is performed,
the code of the Recorder toggles
between “RC-1” and “RC-2”. The front
panel display changes as the code
changes.
• Press
OPERATE
on the remote
control to see if you can turn on/off
the Recorder.
If remote control does not
work
Press
OPERATE
on the remote control and
check the front panel display (RC-1 or RC-2).
Set the remote control code according to the
display and press
OPERATE
to see if you
can turn on/off the Recorder.
NOTE
• If the batteries in the remote control unit are
changed, the code settings must be re-
entered.
• Some brands have more than one code
listed above, due to changes in the codes.
In such cases, try another code to find the
code that operates your TV.
CHANNEL
'
'
'
'
'
/
"
"
"
"
"
Front display
panel
TV Brand
Manufacturer's Code
FERGUSON
07
GRUNDIG
06
HITACHI
13
ITT NOKIA
08
JVC
15
MITSUBISHI
16
PANASONIC 1
11
PANASONIC 2
12
PHILIPS
03
SANYO
14
SHARP 1
01
SHARP 2
02
SONY
09
THOMSON 1
04
THOMSON 2
05
TOSHIBA
10
TV function control
• TV Power: OPERATE
• TV Channel up/down: CH
'
'
'
'
'
/
"
"
"
"
"
• TV Volume up/down: VOL +/-
• TV-AV Selector: INPUT
DV-HR300S-013-019
04.1.14, 3:40 PM
19
