Sharp AR-M160 Service Manual Download

Page: 35 / 112

AR-M205 SIMULATIONS 7-8

Drum counter clear

When the [START] key is pressed, the drum count and the drum roasting time are reset to zero, and
the drum counter value is displayed on the 7-seg LED. When the [Interrupt] key is pressed, the
machine goes into the sub code input standby mode. When the [CA] key is pressed, the simulation is
terminated.

Copy counter clear

When the [START] key is pressed, the copy count value is reset to zero and displayed on the 7-seg
display. When the [Interrupt] key is pressed, the machine goes into the sub code input standby mode.
When the [CA] key is pressed, the simulation is terminated.

Printer counter clear

When the [START] key is pressed, the printer count value is reset to zero and displayed on the 7-seg
display. When the [Interrupt] key is pressed, the machine goes into the sub code input standby mode.
When the [CA] key is pressed, the simulation is terminated.

Scanner counter clear

When the [START] key is pressed, the scanner count value is reset to zero and displayed on the 7-
seg display. When the [Interrupt] key is pressed, the machine goes into the sub code input standby
mode. When the [CA] key is pressed, the simulation is terminated.

SPF jam total counter clear

When the [START] key is pressed, the SPF jam total count value is reset to zero and displayed on the
7-seg display. When the [Interrupt] key is pressed, the machine goes into the sub code input standby
mode. When the [CA] key is pressed, the simulation is terminated.

Scanner mode counter clear

When the [START] key is pressed, the scanner mode count value is reset to zero and displayed on
the 7-seg display. When the [Interrupt] key is pressed, the machine goes into the sub code input
standby mode. When the [CA] key is pressed, the simulation is terminated.

Main motor operation check
(Cooling fan motor rotation check)

When the [START] key is pressed, the main motor (together with the duplex motor for the duplex
model) is driven for 30 sec. At that time, to save toner consumption, if the developing until is installed,
the developing bias, the main charger, and the grid are outputted. Since, in that case, laser discharge
is required when the motor stops, the polygon motor is driven simultaneously. Check if the
developing unit is installed or not. If it is not installed, the above high voltage is not outputted and only
the motor is rotated. After completion of 30 sec operation, the machine goes into the sub code input
standby mode.
*

This simulation must not be executed by forcibly turning on the door open/close switch.

Polygon motor operation check

When the [START] key is pressed, the polygon motor is rotated for 30 sec. After completion of 30 sec
operation, the machine goes into the sub code input standby mode.

Size setting

Used to set Enable/Disable of the FC (8.5" x 13") size detection.

Detection size when a document of the FC ((8.5" x 13") size is used

•For the other destinations, this setting is disabled.

Auditor setting

Used to set the auditor.

When the coin vendor mode is selected, if the auditor setup is ON and the standard tray is

manual feed tray, the standard tray setup must be changed to the main cassette.

Copier duplex setting

When this simulation is executed, the current set duplex code number is displayed. Enter the desired
code number of duplex setting and press the [START] key, and the entered code number is set.

When this simulation is executed, the binding margin setup is automatically set to the default

(left side).

Main
code

Sub

code

Contents

Details of operation

Code number

Setting

0
1

FC detection Disable
FC detection Enable

* Default except for the following
* Default only for SCA/Philippines