Sharp Aquos LC-32WD1E, Operation Manual

Page: 9 / 38

7
Quick start guide
To turn on the TV, press on the remote control or on the
TV.
NOTE :
• If the TV is not going to be used for a long period
of time, unplug the power cord from the AC outlet
to remove AC power.
Press on the remote control when the TV is on.
• This will put the TV into standby mode. The image
on the TV will disappear and the indicator on
the TV will change from green to red. (See
page 5.)
• Small amounts of electrical power are being used
when the TV is in standby mode. To completely
remove power from the TV, unplug the power cord
from the AC outlet.
• There is an active standby mode and a passive
standby mode.
Television rear and side view
EXT 2
(SCART input/output)
EXT 1*
(SCART input/output)
Antenna input
(DVB-T 5V=/80 mA)
EXT 4
(Component input)
Common
Interface slot
(Standby/On button)
(Input button)
(
-
/
+
) (Volume buttons)
P (
/
)
(Programme [channel] buttons)
AC Input
Service (D-Sub 9)
EXT 6 (HDMI input, Stereo input
for DVI-HDMI connections)
Audio output
EXT 5 (VGA / Stereo input)
EXT 7
(HDMI input)
EXT 3 Connections
S-Video input (Y/C)
Composite input (CVBS)
Audio input - Left
Audio input - Right
Headphones (audio out)
*EXT 1 provides tuner output. Use EXT 1 to connect a decoder or
audiovisual equipment used for recording purposes (ex. VCR).
The S-Video (Y/C) and composite (CVBS) connection
cannot be used at the same time.
Turning on the television Standby mode and LED indicator
Page 7 of 204 June 8, 2007
TINS-DO52WJN1
SHPRN000205B-GLDN