Quick guide
Initial auto installation
When the TV is powered on for the first time after purchase,
the initial auto installation wizard appears. Follow the menus
and make the necessary settings one after another.
1
Press
a
on the TV.
The initial auto installation wizard appears.
2
Setting the OSD language.
Press
a
/
b
/
c
/
d
to select the desired language.
3
Setting the country.
Press
▲
/
▼
/
◄
/
►
to select your country or area.
This setting screen only appears during the first
installation.
4
Starting channel search.
Press
▲
/
▼
to select “
Channel tuning
” and then
press
OK
.
If you want to search for more broadcasts,
execute “DTV (or ATV) manual tuning” from the
menu “CHANNEL” (Page 18).
To watch both analogue broadcasts and digital
broadcasts, you should perform the channel
search setting “DTV+ATV”.
•
•
•
•
5
Selecting the TV location.
Press
◄
/
►
to select where you will use this TV, and
then press
OK
.
•
HOME
: For home
.
•
STORE
:
DYNAMIC
mode is predetermined. If the
“
Picture
Mode
” is changed, the TV will automatically
switch back to
“DYNAMIC
” when there is no signal input
from the TV or remote control unit for 30 minutes.
If you have chosen “
STORE
” by mistake, go to “
OPTION
”
→
“
Restore Factory Default
”
→
OK
, and the TV returns
to the initial screen.
6
The TV searches for, sorts and stores all the
receivable TV stations according to their settings
and the connected antenna.
•
To cancel the initial auto installation in progress, press
END
.
NOTE
•
If you turn the power on the TV after performing step 4,
initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the “CHANNEL” menu (Page 18).
•
The initial auto installation wizard will turn off if your leave
the TV unattended for 30 minutes before searching for
channels in step 4.
•
After initial Auto Tuning is completed, the default PIN is
automatically set to “1234”. To change the PIN setting,
refer to “LOCK” menu on page 19.
If you install a DVB-T antenna for the first time of relocate
it, you should adjust the alignment of the antenna to
receive a good reception while checking the antenna
setup screen.
1
Press a channel you want to check.
2
Press
MENU
. “
PICTURE
” menu will appear.
3
Press
◄
/
►
to select “
CHANNEL
” menu.
4
Press
▲
/
▼
to select “
Signal Information
” and
then press
OK
.
5
Position and align the antenna so that the maximum
possible values for “Quality” and “Strength” are
obtained.
NOTE
The values of “Quality” and “Signal Strength” indicate when to
check the appropriate alignment of the antenna.
Checking quality and
signal strength
Home
Store
9
Confirm the following before turning
on the power
Is the antenna cable connected?
Is the AC cord plugged in?
E
E
