Sharp AL-1216, Operation Manual

Page: 21 / 84

19
4
This chapter explains basic and other copying functions.
The unit is equipped with a one-page memory buffer. This memory allows the unit to
scan an original once only and make up to 99 copies. This feature improves
workflow, reduces operation noise from the copier, and provides higher reliability by
reducing wear and tear on the scanning mechanism.
COPY FLOW
1 Make sure that paper has been loaded in the paper tray (p.15)
or multi-bypass tray (p.17), and check the paper size (p.14).
If paper is not loaded, see page 15. If you are using the single bypass, check
the paper size and then proceed to the next step without loading paper.
2 Place the original.
If you are using the original table, see "Using the original table" (p.20).
If you are using the SPF, see "Using the SPF" (p.21).
When copying onto A4 (8-1/2" x 11") paper or a large size, pull out the
paper output tray extension.
4 Start copying.
Press the start ( ) key.
3 Select the copy settings.
If you wish to copy using the initial settings (p.13), proceed to the next step.
To set the number of copies, see page 22.
To adjust the resolution and contrast settings, see page 22.
To enlarge or reduce the copy, see page 24.
AL-1225 model
To change the tray used, see page 25.
If you are using the single bypass
Do not press the start ( ) key. Insert a
sheet of paper into the single bypass.
(Page 18)
Multiple copies are not possible
using the single bypass.
4
MAKING COPIES