420 774 335 397 www.sharks-shop.cz Stránka 49
►
Audio and other home appliances
eg. TV sets, radios, irons, kettles, require electric power projection of 1.5 to 2-fold.
►
Welding machines
On selected models can be connected to welding units (inverters older structures require up to twice
the performance overlap.)
►
Devices capacitive type
such as flashlights, neon fluorescent lamps, etc., they may be powered only by power generators
equipped with synchronous alternator control. For ignition must exceed the exercise headquarters
nameplate wattage appliances 1.5 to 2-fold.
►
AVR (Automatic Voltage Regulation)
system of automatic electronic balancing voltage whose quality output voltage (extermination of up to
± 5%) allows you to power both common appliances and fine electronic (UPS, PC, electrical tools with
regulation, etc.).
►
Automatic system checking the oil level
in the case of low oil level in the crankcase automatically stops the engine and thereby prevent
damage.
Few tips:
Pay careful attention to that used fuel. They are often in the spark plug in the exhaust pipe and
silencer and after a short operation greasy deposits of black carbon. Poor fuel contain oil or other non
evaporable constituents.
Suggests usually greasy dirt on a tank of gasoline spilled during filling. Some tentative evaporative
testing fuel samples demonstrate in both petrol and a fairly high percentage of non-evaporable
substances. These substances cause rapid zakarbonování combustion chamber and exhaust.
Prolonged use of such fuel may lead to engine damage. In some serviced machines, we have already
identified as a fuel that contains corrosive ingredients naleptávající rubber seals, oil seals and hoses!
These types of power generators are built to operate in the open. It is always necessary to ensure the
safe passage of exhaust gases and sufficient cooling of the engine and generator. In no case should
not operate the machine in an enclosed space. Extending the muffler or suction hoses or pipes is
unacceptable
The machine is necessary to send service without gasoline and oil! Filled machine can be dangerous
during transport. It is also necessary to ensure that the machine throughout transport in the horizontal
position (pallet shipments). At large angles may engine oil through the crankcase ventilation flow into
the intake into the combustion chamber and the exhaust out of the engine outside. In many cases then
the removal of oil from all the hard to reach areas in time and in particular the cost-demanding than
removal of the original defect. The original or replacement packaging must prevent the usual
mechanical damage.
