WORKING
STARTING THE ENGINE
WARNING
Once the engine is started, starts cutting head rotate.
1. Place the unit on a flat, hard surface. Hold the cutting head off the
ground and away from the surrounding objects, because after the
engine begins to rotate the head.
2. Several pump the pump until the fuel flowing flowing translucent
tube. (OP1).
3. Move the choke lever to the closed position (OP2).
4. Set the ignition switch to the "Start". While pulling the throttle lever,
press the gas button and release the gas, then the throttle lever in the
"starting position". (OP3).
5. As you hold the unit firmly, quickly pull the starter rope until the
engine starts. (OP4).
(1) choke
(2) Closed
(3) OPEN
(4) of the ignition switch
(5) start
(6) feet
(7) The setting button Throttle
IMPORTANT
Avoid pulling the rope to the end position or the rapid return of the
cable releasing rod. Such actions may cause damage to the starter.
6. Move choke lever to choke down. Restart the engine (OP2)
7. Before starting work, let the engine for a few minutes to warm up.
NOTE
1. To immediately restart the engine after a stop, leave the choke open.
2. Glut may, due to the large amount of fuel, causing hard starting. If
the engine does not even start after several attempts, open the choke
and repeatedly pull the wire rod, or remove the spark plug and dry it.
STOPPING THE ENGINE (OP3)
1. Release the choke lever and run the engine for a half minute.
2. Turn the ignition switch to STOP.
IMPORTANT
Due to the potential hazard, avoid stopping the engine at the moment
of pulling the choke.
THROTTLE CABLE ADJUSTMENT
• Normal clearance is 1-2 mm measured from the end of the
carburetor. If necessary, adjust the clearance using the adjuster cable.
SETTING SPEED idling (OP6)
1. When the engine is idling prone to frequent stopping, turn the
adjustment screw clockwise.
2. When the cutting head rotates after releasing the trigger, turn the
adjusting screw to the left.
NOTE
420 774 335 397 www.sharks-shop.cz Stránka 54
