IMPORTANT: Before starting work, remove all obstacles!
1. check the entire unit. Whether or not loose connections or no
fuel leakage. Make sure that the cutting element is connected
properly installed and securely tightened.
2. Make sure that the cover is securely attached to debris.
3. If the cutting head is a metal blade, replace the cover and
handle and attach the shoulder strap (see. Fig. 42). Before
starting the engine, set the strap into position so that your left
hand can comfortably hold the handle approximately waist
height.
STARTING THE ENGINE
1. Keep standing around people and animals at least 15 meters
away from the job on. If a person approaches you, stop the
engine immediately.
2. The apparatus is equipped with a centrifugal clutch
mechanism, so that the cutting head begins to rotate as soon as
the engine is started. When starting the engine, place the device
on the ground on a flat, clean surface and hold it firmly in place
so that when you start come absolutely no cutting part nor the
throttle into contact with any obstacle.
WARNING
Make sure the throttle is in the rest position.
When starting the engine Never place the flap in the position
of high speed or half position (locked position of the flaps).
1. After starting the engine, check the cutting links (head) stops
rotating when the throttle is fully switched back to its original
position (resting position of the throttle). If the rotation continues,
even if the throttle is switched completely backward, turn off the
engine and take the equipment dealer for repair.
USING THE PRODUCT
IMPORTANT!
Mow only materials specified by the manufacturer. Use only
load explained in the manual.
420 774 335 397 www.sharks-shop.cz Stránka 49
