scorpio 1000/2000
5.4 2.5" HDD cage
1. Insert a 2.5“ HDD/SSD into a drive bay of the 2.5“ HDD cage until
it locks inside the pre-installed plastic rail (fig. 13).
fig. 13
2. Connect the inserted HDD to the mainboard.
6. Installing a PSU
1. Put the PSU from the inside against the PSU bracket on the case’s
back side (fig. 14).
fig. 14
Note:
The PSU may be installed in two different directions: either the
fan points upwards (towards the mainboard) or the fan points
downwards (towards the floor).
2. Screw the PSU to the case from the outside (fig. 15).
(Screws for PSU mounting)
fig. 15
3. Connect the circuit board’s 4-pin power connector to a matching
power plug of the PSU (fig. 16).
fig. 16
Summary of Contents for SCORPIO 1000
Page 1: ...Manual...
