7
OPERATING INSTRUCTIONS
4. To change the speed of the brush roll, press the speed control button once. One
light “
On
” indicates the unit is on the optimal speed for cleaning hard floors. Two
lights “
On
” indicate the unit is on the optimal speed for cleaning carpets. (Fig. 10)
Anti-Jam Brush Roll Feature
This feature protects your unit’s motor from damage due to overheating, that may be
caused by the rotating brush getting jammed or tangled in something. If the rotating
brush becomes overloaded it will stop turning and both speed indicator lights will
remain flash at the same time. To reset the unit:
1. Press On/Off switch.
2. Remove the transparent brush cover from the sweeper power head to remove any
build up of lint, hair or fiber on the rotating brushes.
3. Wait for 10 seconds to allow the unit to cool down.
4. Press “On/Off switch again, the unit should restart.
Fig. 10
Fig. 9
3. To release the handle to a comfortable position, gently apply pressure to the top of
the sweeper head with your foot while pulling back on the handle. (Fig. 9)
5. To sweep under furniture, press the handle release button and apply pressure in
order to bend the sweeper’s handle forward. The top forward folding pivot will
release from the locked position for increased range of motion, allowing you to
easily reach under sofas, beds, and chairs. (Fig.11)
Fig. 11
Floor
Carpet
8
OPERATING INSTRUCTIONS
Fig. 13
Fig. 12
Fig. 14
Cleaning the Dust Container
To achieve the best performance, empty the dust container after each use.
1. Press the dust cup release lever with your foot. (Fig. 12)
Note
:
Be careful not to accidentally turn the unit “On”
2. Lift out the dust container, which is connected to the handle. Hold over a trash bin
and push down on the no touch empty button located on the handle. (Fig. 13)
3. To close the dust container press firmly on the bottom panel until it snaps back into
place. To replace the dust cup, position onto the sweeper power head and press
down firmly until it snaps back into place.
4. Periodically remove the transparent brush cover on the front of the cordless
sweeper and remove any build up of lint, hair or fiber on the rotating brush.
To remove the cover - grip the cover from the bottom, pull out and upward until the
cover unlocks from the side slots and tabs located on the top of the sweeper.
Carefully cut away threads or hair with scissors. (Fig. 14)
Caution:
Do not accidentally turn unit on while cleaning.
Caution:
Any electronic or electrical appliance should not be stored in or
exposed to areas of high heat or humidity. Do not store your cordless sweeper
close to stoves, radiators, furnaces or in a bathroom or bathing area
.
One Touch
Empty Button
