Shark SKWAL 2, Owner'S Manual, Page: 7 / 11

12 13
A
C
B
D
TEXTILE PARTS - REPLACE TEXTILE PARTS - CLEANING
REPLACE
- Start the operation by engaging the plastic part of
the front of the head section in its housing beginning
with one side (Fig. A).
Replace the rear part of the head section within its
housing (B).
- Position the textile part correctly.
- Reposition the cheek pads by passing the chin
straps through the slit in the foam (Fig. C).
- Replace the neck pad, inserting one of its side parts,
then position it correctly in its housing (D).
WARNING! If you have any doubt what-
soever regarding the removal or replace-
ment of the interior padding, DO NOT USE YOUR
HELMET. Contact your retailer for assistance or
advise. NEVER use your helmet with any part of
the interior padding removed. The helmet will not
protect you in an accident.
WARNING!
Damaged interior padding
will compromise the fit of your helmet on
your head and could allow the helmet to come
off your head in an accident, resulting in a head
injury or death.
THE TEXTILES
The SKWAL 2 make it easy for you to ap-
preciate fully the performance of your helmet.
The parts in contact with the skin are made
in a fabric that is guaranteed to feel pleasant,
to absorb perspiration well and to resist wear
satisfactorily. We treat surfaces to limit the
risk of mould and bacteria.
WARNING! Although they are selected
for their quality of resistance and satis-
factory wear, all the interior padding is subject
to normal wear depending on use and care
and maintenance, the length of use and also
the degree of acidity of your perspiration. If
you note any wear, we
advise you to replace the interior padding
in order to keep your helmet perfectly clean
and comfortable.
Your SHARK supplier can propose you with
replacement parts and also offer you cheek
pads of different thicknesses and densities,
should the standard selection not correspond
to the contours of your face.
CLEANING THE INTERIOR
The interior textile parts are washable; it is im-
portant to follow the instructions below scru-
pulously to avoid damaging them:
The cheek pads and head section must be
hand washed in warm, soapy water (about
30°).
Do not use aggressive detergents but
either a product for delicate materials in
low dilution or household soap. It is essential
to dry textile and foam parts completely before
using them. They must be dried at room tem-
perature. Never iron textile parts. For parts with
a leather appearance or textiles attached to
safety elements, use a slightly damp sponge or
cloth and household soap and rinse with clean
water.
Avoid allowing too much water to
come into contact with polystyrene parts.
WARNING!
It is essential to ensure that
all interior parts are perfectly dry before
using the helmet.
WARNING!
SKWAL 2 Only: The batte-
ry feeding the LED as its electric cable
could be damaged by the moisture of fabrics
and corrode.