11
CUSTOMER CARE - NZ: 0800 002 999
Using Your Portable Steam Pocket
®
- cont’d
GENERATING STEAM
CAUTION: Steam is hot and can cause burns,
so please use with caution.
1
Plug the unit in and wait about 30 to 45 seconds
then press and hold the steam trigger to activate the
pump. You will immediately hear steam generating
and begin to see visible results either from the nozzle
or the attached cleaning tool. It is recommended
that you wait at least 30 seconds before pulling the
trigger as this will minimise water spitting.
2
Once you release the steam trigger, the pump will
stop delivering water to the boiler and the steam will
reduce to a stop when the boiler becomes empty.
3
For wedge and cylinder cleaning pockets, allow the
bottle to generate enough steam to activate the
cleaning fabric. Once you see visible steam emitting
through the fabric, your cleaning pocket is ready to
use. Some messes, particularly those that are sticky
may require more moisture, so allow more steam
to generate and exhaust from the cleaning pocket
before cleaning.
WARNING: Your portable Steam Pocket
®
is
designed to clean surfaces that will withstand
high heat and moisture. Do not use on
unsealed wood surfaces (especially wooden
antique furniture), unglazed ceramic tile, or
surfaces that have been treated with wax,
oils, varnishes, or shellac. The sheen may be
removed by the heat, steam, and friction of
the cleaning tools. Lacquer and polyurethane
coatings provide a hard durable protective
finish that withstands moisture but it is
always recommended to test an isolated
area of the surface to be cleaned before
proceeding. We also recommend you check
the use and care instructions from the surface
manufacturer.
IMPORTANT: Once plugged in, the Blue LED
will illuminate, and your portable Steam
Pocket
®
cleaning system will be ready to use
within 30 seconds.
NOTE:
Make sure surfaces are free of crumbs and
debris before using the portable steam pocket.
Large objects may not be picked up by the Steam
Pocket
®
and will only be pushed around.
