7
AU
sharkclean .com . au
NZ
sharkclean .com . nz
AU
02 8 8 01 76 6 6
NZ
0 8 0 0 112 6 60
IMPORTANT: Make sure you DO NOT use the Steam Mop without attaching a Dirt Grip
™
pad and adding water
to the water tank first. When you use the Steam Mop for the first time, it might take longer than the normal 30
seconds to start steaming.
IMPORTANT: DO NOT use on unsealed wood or unglazed ceramic floors. On surfaces that have been treated with
wax and on some no-wax floors, the sheen may be removed by the heat and steam action. Test an isolated area
of the surface to be cleaned before proceeding. Check the use and care instructions from the floor manufacturer.
Using Your Steam Pocket
®
Mop
fig. 9
fig. 10
fig. 11b
fig. 11a
NOTE:
To prolong the life of your Steam Mop, we
recommend using distilled water.
NOTE:
Sweep or vacuum your floors prior to
cleaning with your Steam Mop.
1
Twist the Quick-Release Cord Holder to unwrap
the power cord completely.
(fig. 9)
Plug into an
electrical outlet. The blue light will illuminate. It
takes approximately 30 seconds for the Steam Mop
to heat up.
2
Pump the handle a few times, pushing the handle
toward the mop head in a downward, fast pumping
motion. This pumping action will release steam as
you mop with a forward or backward motion.
3
Begin mopping with a forward and backward
motion. The natural motion of mopping will produce
steam. Customize the amount of steam by mopping
slowly for less steam and quickly for more steam.
4
When you need an extra burst of steam to clean
a stuck-on stain, you can use the Steam Blaster
™
feature. Flip the head over so that it is behind the
mop body, then tilt the mop handle down. This
will cause the Steam Blaster
(fig. 10)
to emit a
concentrated blast of steam onto the stain.
CAUTION: While in Steam Blaster mode,
DO NOT leave stationary for more than one
minute.
CAUTION: DO NOT scrub any one area for an
extended period of time.
5
To stop the Steam Blaster spray, simply raise the
handle. You can then flip the mop head back into its
original position and continue cleaning.
6
To remove the Dirt Grip pad, simply lift the Steam
Mop straight up by the handle until the Klik n' Flip
®
Mop Head is hanging straight down. Press the
Release button on the back of the Steam Mop body
(fig. 11a)
, and both sides of the head will drop open,
releasing the pad.
(fig. 11b)
7
Once the Dirt Grip pad has been released, close
the Klik n' Flip Mop Head. To close, gently press
one side of the mop head to the floor until that side
clicks into place. Repeat on the other side.
8
When the water tank is empty, the Steam Mop will
stop producing steam. You can refill the water tank
at any time as long as the Steam Mop is unplugged.
Follow the water tank filling instructions on page 6.
NOTE:
Please wait 2 to 3 minutes for the Steam
Mop to cool off before switching the mop head.
NEVER
leave the Steam Mop with a damp/wet Dirt
Grip pad on any floor for an extended period of time.
