97-610, 97-6152 • REV. 7/04
OPERA
T
OR’S MANU
AL
PRESSURE W
ASHER
6
CAUTION: Hot discharge fluid.
Do not touch or direct dis-
charge stream at persons.
9. Never make adjustments on
machine while in operation.
WARNING: High pressure can
cause paint chips or other par-
ticles to become airborne and
fly at high speeds.
10. Eye safety devices and foot
protection must be worn
when using this equipment.
WARNING: Risk of asphyxia-
tion. Use this product only in a
well ventilated area.
11. When the machine is work-
ing, do not cover or place in
a closed space where venti-
lation is insufficient.
12. Machines with spray guns
should not be operated with
the trigger in the off position
for extensive periods of time as this may cause
damage to the pump.
13. Protect from freezing.
14. Be certain all quick coupler fittings are secured
before using pressure washer.
15. Do not allow acids, caustic, or abrasive fluids to
pass through the pump.
16. Inlet water must be cold and clean fresh water.
17. To reduce the risk of injury, close supervision is
necessary when a machine is used near children.
Do not allow children to operate the pressure
washer. This machine must be attended during
operation.
18. The best insurance against an accident is precau-
tion and knowledge of the machine.
19. Do not operate this product when fatigued or un-
der the influence of alcohol or drugs. Keep operat-
ing area clear of all persons.
20. Do not replace LP tank while machine is running.
Serious injury could result.
WARNING: Use only vapor pro-
pane fuel.
21. This equipment is designed
to run on vapor fuel. Do not
use liquid fuel. Have a quali-
fied serviceman install and
service your equipment.
22. Never expose a spark or
flame where unburned gas
may be present.
23. Never attempt to light pilot unless pilot manual
valve has been shut off for 5 minutes.
24. A conversion kit, as supplied by the manufacturer,
shall be used to convert natural gas to propane.
25. L.P. gases are heavier than air and will spill out on
the floor. Therefore always provide adequate space
and ventilation around these machines. Install
machine 18" above the floor.
26. Manufacturer will not be liable for any changes
made to our standard machines, or any compo-
nents not purchased from the manufacturer.
27. Do not overreach or stand on unstable support.
Keep good footing and balance at all times.
28. Follow maintenance instructions specified in the
manual.
29. When making repairs disconnect from electrical
source and shut off gas valve.
30. Turn burner off, open spray gun and cool to 100°
F before turning machine off.
31. Extinguish any open flame
and test all joints with a soap
solution. If odor persists, call
your gas supplier immedi-
ately.
32. Not suitable for connection
to Type B gas vent if the stack
temperature exceeds 243° C
(470° F).
33. A draft diverter shall be installed if this machine is
going to be permanently installed and vented to
the outside of the building.
WARNING
RISK OF
ASPHYXIATION.
USE ONLY IN A WELL
VENTILATED AREA.
RISK OF EXPLOSION:
IF GAS SMELL
PRESENT TURN
OFF SUPPLY
WARNING
WARNING
EXTREMELY HOT:
USE CAUTION WHEN
OPENING LID.
WARNING
PROTECTIVE
EYEWEAR AND
CLOTHING MUST
BE WORN.
WARNING
RISK OF FIRE.
DO NOT USE WITH
FLAMMABLE LIQUIDS.