Shark HNG-3010, Operator'S Manual, Page: 4 / 36

4
HNG SERIES PRESSURE WASHER
OPERATOR’S MANUAL
CAUTION: Hot discharge fluid. Do
not touch or direct discharge
stream at persons.
9. Never make adjustments on
machine while in operation.
WARNING: High pressure can
cause paint chips or other par-
ticles to become airborne and fly
at high speeds.
10. Eye safety devices and foot pro-
tection must be worn when
using this equipment.
WARNING: Risk of asphyxiation.
Use this product only in a well
ventilated area.
11. When the machine is working,
do not cover or place in a closed
space where ventilation is insuf-
ficient.
12. Machines with spray guns
should not be operated with the
trigger in the off position for extensive periods of time
as this may cause damage to the pump.
13. Protect from freezing.
14. Be certain all quick coupler fittings are secured
before using pressure washer.
15. Do not allow acids, caustic, or abrasive fluids to pass
through the pump.
16. Inlet water must be cold and clean fresh water.
17. To reduce the risk of injury, close supervision is nec-
essary when a machine is used near children. Do
not allow children to operate the pressure washer.
This machine must be attended during opera-
tion
.
18. The best insurance against an accident is precau-
tion and knowledge of the machine.
19. Do not operate this product when fatigued or under
the influence of alcohol or drugs. Keep operating area
clear of all persons.
20. Do not replace LP tank while machine is running.
Serious injury could result.
WARNING: Use only vapor fuel.
21. This equipment is designed to
run on vapor fuel. Do not use
liquid fuel. Have a qualified ser-
viceman install and service
your equipment.
22. Never expose a spark or flame
where unburned gas may be
present.
23. Never attempt to light pilot unless pilot manual valve
has been shut off for 5 minutes.
24. A conversion kit, as supplied by the manufacturer,
shall be used to convert natural gas to propane.
25. L.P. gases are heavier than air and will spill out on
the floor. Therefore always provide adequate space
and ventilation around these machines. Install
machine 18" above the floor.
26. Shark will not be liable for any changes made to our
standard machines, or any components not pur-
chased from Shark.
27. Do not overreach or stand on unstable support. Keep
good footing and balance at all times.
28. Follow maintenance instructions specified in the
manual.
29. When making repairs disconnect from electrical
source and shut off gas valve.
30. Turn burner off and cool to
100° F before turning machine
off.
31. Extinguish any open flame and
test all joints with a soap solu-
tion. If odor persists, call your
gas supplier immediately.
32. Not suitable for connection
to Type B gas vent if the stack
temperature exceeds 243° C
(470° F).
33. A draft hood shall be installed if this machine is
going to be permanently installed and vented to the
outside of the building.
INSTALLATION
Place machine in a convenient location providing ample
support, drainage and room for maintenance (see page 5).
Location:
The location should protect the machine from damaging
environmental conditions, such as wind, rain and freezing.
1. The machine should be run on a level surface where
it is not readily influenced by outside sources such
as strong winds, freezing temperatures, rain, etc. The
WARNING
RISK OF
ASPHYXIATION.
USE ONLY IN A WELL
VENTILATED AREA.
RISK OF EXPLOSION:
IF GAS SMELL
PRESENT TURN
OFF SUPPLY
WARNING
WARNING
EXTREMELY HOT:
USE CAUTION WHEN
OPENING LID.
WARNING
PROTECTIVE
EYEWEAR AND
CLOTHING MUST
BE WORN.
WARNING
RISK OF FIRE.
DO NOT USE WITH
FLAMMABLE LIQUIDS.