Shark HNG-3010, Operator'S Manual, Page: 10 / 36

10
HNG SERIES PRESSURE WASHER
OPERATOR’S MANUAL
YES NO
Has gas supply been inspected by an
authorized contractor to meet local codes?
Is machine protected from downdraft and
excessive wind?
Is machine shielded from moisture or water
spray?
Is the voltage correct and are the circuit
breaker and supply cord adequate
according to specifications and serial plate
notation?
Is the machine electrically grounded?
Is there ample water supply?
Have all flammable liquids or gases been
removed from installation location?
Is there adequate gas supply for the BTU
rating of the burner?
Is incoming gas supply pressure between
6 - 14 water column inches or 1/2 PSIG?
Has the proper gas regulator been
installed for pressure and volume?
Is the machine properly vented to allow
adequate air flow?
Are the propane tanks large enough,
according to rating to prevent freezing?
Have gas lines been checked for gas
leaks?
Have gas lines been checked with local
codes?
Have all operators using this machine
been instructed properly & have they read
the manual?
Has the machine been installed according
to operator's manual instructions?
CHECK LIST BEFORE
STARTING:
CAUTION! If “NO” is checked on any of the following
sixteen questions, do not operate this machine.
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
If you do not follow these instructions exactly, a fire or
explosion may result, causing property damage, personal
injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
FOR YOUR SAFETY
"WHAT TO DO IF YOU SMELL GAS"
• Do not try to light any appliance.
• Do not touch any electrical switch, do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your supplier, call the fire department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand, don't try to repair it; call a qualified service
technician. Forced or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.