INSTALLING AND REMOVING THE FILTER
NOTE:
Always remove all protective packaging from the filter before installing.
When the filter timer has 0 hours remaining, the
MAX
button on the top control panel will blink, indicating that it’s time to install a new filter.
1.
Turn off and unplug the unit before removing or installing filters.
2.
Remove the back cover from the unit by pressing the tabs at the
top (1), then pulling the cover toward you.
3.
To remove the old filter, pull it out by the tabs at the top and
bottom of the filter (2). Discard old filter in dustbin.
4.
Remove all packaging and wrapping from the new filter.
5.
Insert the new filter, then replace the filter cover. Insert the tabs
on the bottom of the cover into the slots on the unit (3). Press
the top of the cover, then the sides, until it clicks into place.
6.
Plug the unit back in and turn on power. Calibration will begin.
7.
After installing a new filter, press and hold the
MAX
button on the
top control panel for 3 seconds to reset the timer. The unit will
beep when the timer is activated.
Disposing of used filters
Filters cannot be cleaned or recycled. After removing a used filter, wrap it in an airtight plastic bag for disposal. As an extra precaution, wear
gloves when handling a dirty filter.
MAINTAINING YOUR AIR PURIFIER
NOTE:
Always unplug the unit before doing any cleaning or maintenance.
Exterior Cleaning:
For best results, clean the exterior of the unit every two months or
as needed. Use a microfibre cloth to remove dust. To sanitise, wipe
down the exterior with a microfibre cloth dampened with warm,
soapy water. Avoid excess water and abrasive chemical cleaners to
prevent damage.
Interior Cleaning:
For best results, clean the interior of the unit every two months
or as needed. Remove the filter cover, take out the filter, and
use a vacuum cleaner or a microfibre cloth to remove dust and
debris from the interior of the unit.
DO NOT
use abrasive chemical
cleaners on the inside of the unit.
3
2
Remove
filter
from
plastic
packaging
1
