sharkclean .com/AI RobotS E
sharkclean .com/AI RobotS E
CLEANING SENSORS AND CHARGING CONTACTS
CLEANING SIDE BRUSHES
LIDAR MODULE
MAINTENANCE
!
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a dry cloth. To reinstall,
snap the brushes over the pegs. Spin the brushes
manually to make sure they are installed correctly.
Use a dry rag to clear out any debris underneath and
around the LIDAR module. It may be necessary to
use scissors to cut away hair wrap. Clean the module
once a month, or when dirt or debris is visible.
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED.
With a dry cloth, gently dust off the sensors
and contacts located on the bottom of the robot and on the base.
NOTE:
Remove and replace any side brushes that are bent or damaged. To remove a brush, lift it off its peg.
IMPORTANT:
The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.
CLEAN SIDE BRUSHES AS NEEDED.
SELF-CLEANING BRUSHROLL
MAINTENANCE
The
Self-Cleaning Brushroll
actively removes hair wrap while your robot cleans. If some debris remains
wrapped around the brushroll, continue to run the robot to give the brushroll time to clean itself. If some hair
wrap or debris remains after continued cleaning, carefully remove it from the brushroll.
To access the brushroll, push up on the tabs on the
brushroll door, then lift off the door.
Lift out the brushroll and remove any debris.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll door and press down until both
sides click into place.
NOTE:
Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
