44
Period: Click set button, you can see an interface is shown as in Figure 4-25.Here you can set
motion detect period. System only enables motion detect operation in the specified periods. It is not
for video loss or the camera masking. Please select Sunday to Saturday from the dropdown list.
You can see there are six periods for you to set. Please note you need to check the box before the
period to enable the period setup valid. In Figure 4-25, select work day or non-work day from the
drop down list, and then click the Set button, you can set your own business day and non -business
day setup. See Figure 4-26. You can set Monday to Friday as the working day and Saturday and
Sunday as non-business day. Click Save button to go back to previous interface.
Anti-dither: System only memorizes one event during the anti-dither period. The value ranges from
5s to 600s.
Show message: System can pop up a message to alarm you in the local host screen if you enabled
this function.
Alarm upload: System can upload the alarm signal to the network (including alarm centre) if you
enabled current function.
Send email: System can send out email to alert you when alarm occurs.
Record channel: System auto activates motion detection channel(s) to record once an alarm occurs.
Please make sure you have set MD record in Schedule interface(Main Menu->Setting->Schedule)
and schedule record in manual record interface(Main Menu->Advanced->Manual Record)
PTZ activation: Here you can set PTZ movement when an alarm occurs. Such as go to preset, tour
&pattern when there is an alarm. C
lick “
select
” button
, you can see an interface is shown as in
Record Delay: System can delay the record for specified time after alarm ended. The value ranges
from 10s to 300s.
Tour: Here you can enable tour function when alarm occurs. System one-window tour. Please go to
chapter 5.3.7 Display for tour interval setup.
Snapshot: You can enable this function to snapshoot image when an motion detect alarm occurs.
Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
Test: Click it to test current motion detect setup (do not need to save). Click Select button after
Region, you can set motion detect area. The default setup is whole region. The blue zones are the
selected area. Please set sensitivity and click Test button, you can see system only display motion
detect status of the blue area. The red flashing area is current motion detect. See Figure 4-28.
Please highlight icon
to select the corresponding function. After all the setups please click Save
button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in each
channel may not be the same.
In Figure 4-23, you can left click mouse and then drag it to set a region for motion detection. Click Fn to
switch between arm/withdraw motion detection. After setting, click enter button to exit.
