Shannon HRP 220, User Manual

Page: 21 / 50

User’s Guide
HRP 220 - 20 -
HS
Adjustment 8
8.5 UPPER FILAMENT HEIGHT
Make sure that the lower and upper heating elements and the
pressure bars are in the correct position.
1.
Switch on the top frame (switch D , page 11).
2.
Set the timer ( K , page 16) to 9999 sec.
With this time setting the machine will remain closed for
long enough to adjust the filament height.
3.
Place a test piece of the plastic to be processed on the
working surface.
4.
Lower the top frame (switch H , page 11).
5.
Adjust the height of the filament using the adjusting nuts
on the upper heating elements.
You can set the filament to a minimum of 6 mm above the
plastic.
Adjust the height so that the element is clear of the plastic.
6.
Open the top frame (Switch G , page 12).
7.
Reset the timer ( K , page 12).
8.
Start the machine again as in Section 7 .
Adjusting nuts
5