User’s guide
HRK 65-125
-
15
-
HS
Operation
7
7.4
TROUBLE SHOOTING
7.5
SETTING CYCLE TIME
The time during which the machine is closed to heat the plastic sheet on two sides can be set
on the timer unit.
At first use of the machine, set E = 5 and F = 20 (See 5.3)
1.
Switch between values with the
▼
/
▲
buttons.
2.
Increase or decrease the value with the +/- buttons.
3.
Cancel the value with the “ESC” butto
n.
4.
Confirm the value with the “OK” button.
7.6
FOOT SWITCH
The top frame is served by pressure on the pedal of the foot switch.
7.7
SETTING AIR PRESSURE
The pressure for the system is adjusted by the factory on the right value (6 bar)
Error message
Meaning
Solution
E1
The wire is loose (not connected)
Turn off the machine, check the filament, and reset the
machine
(see
§9.1
for changing filament)
Note: Between the values 00 and 04, this fault cannot be
detected
E2
The wire is loose (spark detection)
Check the connection of the filament
Check the filament, and reset the machine
This fault can also be reset by the arrow down button
(see
§9.1
for changing filament)
E9
Broken circuit board
Contact the supplier for a new circuit board
Empty display
No power
Alert a maintenance engineer
Check the fuse (see
§10.1
)
Check the power supply cable
Contact the supplier if necessary
