User’s guide
HRK 65-125
-
14
-
HS
Operation
7.1
PREPARATION
1.
Check that the air pressure is connected
2.
Clear the working surface
3.
Check that all the heating elements are connected to the control units.
4.
Check that no scraps of material remain in the reflectors.
5.
Check that all the upper heating elements and pressure bars are firmly attached
to the top frame.
7.2
SWITCHING ON HEATING ELEMENTS
Each heating element can be switched on and controlled individually.
1.
Switch on the desired control unit with switch (
H
). See 5.4
7.3
SETTING TEMPERATURE
The temperature of the filament can be set using the temperature control.
1.
When turning on the on/off switch, the display will show the value that was last saved
(keeping the machine on a certain value for >20 seconds will make it remember this
value).
2.
Press the right button (arrow up) to increase the value, up to 99 (keeping this pressed in
will make the value cycle much faster)
3.
Press the left button (arrow down) to decrease the value, down to 00 (keeping this
pressed in will make the value cycle much faster)
4.
Press both buttons at the same time to go directly to 00. Doing this also resets the
machine.
7
