High-Flying
Low Power WiFi Module User Manual
Shanghai High-Flying Electronics Technology Co., Ltd
www.hi-flying.com
- 24 -
2.6. Parameters Configuration
HF-LPB100 module supports two methods to configuration parameters
: Web Accessing
and
AT+instruction set.
Web accessing means users can configure parameters through Web browser. When HF-LPB100
module connected to wireless network, parameters configuration is done on a PC connected to the
same wireless network.
AT+instruction set configuration means user configure parameters through serial interface command.
Refer to “AT+instruction set” chapter for more detail.
2.7. Firmware Update
HF-LPB100 module supports two on-line upgrade methods:
Webpage Wi-Fi Upgrade
Remote Upgrade
Webpaged based Wi-Fiupgrade,please refer to 3.1.8 firmware upgrade page , user can upload
firmware file from PC to HF-LPB100.
HF-LPB100 module also support upgrade from remote HTTP server, keep module connects to AP
router before excuate remote HTTP upgrade. Remote upgrade have two methods:
Direct Download
and Upgrade
,
Configure File Based Upgrade
.
Configure File Based Upgrade
AT+UPURL command to set the remote directory which the configuration file located, such as
AT+UPURL=http://www.hi-flying.com/!admin/down/
Notes: The last ’/’ can’t be remove
AT+UPFILE command to set the configuration file name, such as AT+UPFILE=config.txt
AT+UPST command to start remote Application upgrade. After excuate this command, the module will
firstly download configuration file (“config.txt”), then download the upgrade file base on the URL
address listed in the configure file.
AT+UPWEB command to start remote Webpage upgrade. After excuate this command, the module
will firstly download configuration file (“config.txt”), then download the upgrade file base on the WEB
address listed in the configure file.
AT+UPCFG command to start remote Factory Config upgrade. After excuate this command, the
module will firstly download configuration file (“config.txt”), then download the upgrade file base on the
CFG address listed in the configure file.
AT+UPNVR command to start remote NVRAM Data upgrade. After excuate this command, the
module will firstly download configuration file (“config.txt”), then download the upgrade file base on the
NVR address listed in the configure file.
AT+UPAUTO command to start remote upgrade. After excuate this command, the module will firstly
download configuration file (“config.txt”), then download the upgrade file base on the URL,WEB,CFG
address listed in the configure file. It include the functions of AT+UPST,AT+UPWEB,AT+UPCFG.
HF-SH01
