-12V
www.shakmat.com
•
07/19
Flip the PCB and place a 4 pin male
header, with the short pin side
through the hole. We will solder these
four headers one by one. Be sure to
lay them flat and upright. Those
headers will later join the two PCBs
together so they need to be perfectly
perpendicular.
We recommend you only solder one
of the pins. Then reheat your solde-
red point and simultaneously press
the plastic part of the header against
the PCB until it’s flat. Take off the
soldering iron but keep pressing.
Avoid touching the pins themselves
because they will become hot very
quickly and move out of alignment
within their plastic bracket. Once you
are satisfied with you placement,
solder the remaining pins.
4.2
Back
4.2.1
Male headers (4pin) (x4)
P2
