DOCUMENT
943200-11 ETM RECORDER
Control
SC1
INSTALLATION MANUAL
Revision
–
M943200-11
Page: 14 of 17
SHADIN AVIONICS
www.shadin.com
Customer Service: (952) 836-2269
6
OPERATIONAL MODES AND PROCEDURES
The ETM Recorder will enter one of two operational modes at power up, Record mode or USB Data
Download mode. The ETM Recorder will remain in the same mode until power is cycled. The ETM Recorder
software determines the mode by trying to access the external USB Flash drive when power is first applied.
The procedures for the two modes are listed below:
6.1
RECORD MODE
Operator instructions
1. Verify USB Flash drive is not installed prior to power up
2. Apply power
o
LED
– flashes Orange until first ETM message is received then transitions to solid Green for
the duration of the flight.
Note:
If the operator does not remove the USB Flash drive prior to power up, the
ETM Recorder will remain in USB Data Download mode and will not record ETM data.
6.2
USB DATA DOWNLOAD MODE
Operator instructions
1. Install USB Flash drive prior to power up
2. Apply power
3. Wait for the LED to stop flashing Red
4. The data copy is complete when the LED is solid Green
5. Remove the USB Flash drive
Note: Do not leave the USB Flash drive in the ETM Recorder.
6.3
GROUND BASE SOFTWARE
To import the ETM Recorder data into FleetView:
1. Insert the USB Flash drive into a Window PC
2. Execute FV_import
