Shadin Avionics 943200-11, Installation Manual

Page: 12 / 17

DOCUMENT
943200-11 ETM RECORDER
Control SC1
INSTALLATION MANUAL
Revision
–
M943200-11 Page: 12 of 17
SHADIN AVIONICS
www.shadin.com Customer Service: (952) 836-2269 service@shadin.com
5.1.3.1 SET ETM OUTPUT SELECT TO PRINTER MODE
It is required that an ETM is configured to “Printer” mode prior to use with the ETM Recorder.
Instructions to set the ETM “Output Select” to “Printer” mode:
1. Place the ETM Display rotary switch in the ETM position.
2. Simultaneously hold the Page switch to DOWN and the Start/Stop switch to STOP for 10
seconds. This commands the ETM to Data Entry Mode.
3. After the ten (10) seconds have elapsed, the system will prompt you to enter your password.
4.
Enter the password if applicable. The default password is “A”. Use the INCR/DECR switch to
navigate to “A”, press “ENTER/TEST” button and press the “RECORD” button.
5.
Toggle the Page UP/DOWN switch to get to “Output Select” page.
6.
Use the INCR/DECR switch to change to “Printer” mode and press the “RECORD” button. If
the selection is accepted the ETM Display will display “Taken”.
7. Following the ETM configuration changes, exit Data Entry Mode by toggling the Start/Stop
switch to STOP.
5.1.3.2 SET ETM REGISTRATION
It is recommended that an ETM registration number is loaded in the ETM prior to use with the ETM Recorder.
The initial message sent from the ETM contains the registration number used by the ETM Recorder. The
ETM Recorder assigns a file name based on the ETM registration number for engine trend data analysis.
Instructions to set the ETM “Registration”:
1. Place the ETM Display rotary switch in the ETM position.
2. Simultaneously hold the Page switch to DOWN and the Start/Stop switch to STOP for 10
seconds. This commands the ETM to Data Entry Mode.
3. After the ten (10) seconds have elapsed, the system will prompt you to enter your password.
4.
Enter the password if applicable. The default password is “A”. Use the INCR/DECR switch to
navigate to “A”, press “ENTER/TEST” button and press the “RECORD” button.
5. Place the ETM Display rotary switch in the NAV position.
6. Toggle the Page UP/DOWN s
witch to get to “Registration” page.
7. Use the RESET button to change letters, numbers, special characters or spaces, use the
INCR/DECR switch to scroll through the characters and press the “ENTER/TEST” button to
accept and move to next. Upon completion of the registration characters press the
“RECORD” button. If the selection is accepted the ETM Display will display “Taken”.
8. Following the ETM configuration changes, exit Data Entry Mode by toggling the Start/Stop
switch to STOP.