Shademaker SR-27S, Owner'S Manual

Page: 7 / 12

5
6
I N S T A L L A T I O N O P T I O N S A N D G U I D E L I N E S
There are four standard installation options which provide the best stability for the Sirius.
Depending on your situation, you will have requested one or more of the Sirius base options
at the time of your order.
1. CONCRETE MOUNT KIT - This kit includes a base plate, four (4) plate bolts, and
one (1) allen wrench.
2. IN-GROUND MOUNT KIT - This kit includes in-ground fitting, four (4) plate bolts,
and one (1) allen wrench.
3. STEEL BASE WEIGHT - 213 lbs. Square steel base weight is available (SM PLATE
required). We recommend a minimum of 400-600 lbs. of steel base weights for this
umbrella (depending on the size of your umbrella).
4. FREE STANDING STEEL FRAME - You may opt to use a free standing base for
your Sirius umbrella. We recommend a minimum of a 350-450lbs. base weight for
this umbrella (depending on the size of your umbrella).
NOTE: If using a free-standing
steel frame, wind guidelines change from light to moderate winds to light winds only.
NOTE: REFER TO BASE WEIGHT MATRIX AND SEPARATE
MANUAL FOR BASE ASSEMBLY PRIOR TO PROCEEDING.
(Astral-TC Internal Stem shown)
Installing Internal Stem
Option A: If you wish to use optional internal stem cover, proceed below.
Otherwise, if you wish to not use cover and for a quicker installation, skip to
Option B on page 7.
Remove internal stem from bottom of mast. Install internal stem onto mount kit, SM
PLATE or steel base frame with supplied 5 bolts and washers using allen wrench.
Do
not completely tighten
.
Note:
Do not use power drill. May cause damage to umbrella.
A S S E M B L Y I N S T R U C T I O N S
Two-person team is recommended for assembly.
By now, you have installed your mount kit, SM PLATE onto your steel base weight, or
have set up your steel base frame with recommended base weight.
(Astral-TC Internal Stem shown)
Slide internal stem cover over bottom of Sirius mast. Using a two person team, lift
umbrella with cover and insert bottom of mast onto internal stem. Tighten 5 bolts to
secure umbrella in place with allen wrench.
Note:
Do not use power drill. May cause
damage to umbrella. Slide internal stem cover down to cover internal stem. Once
complete, proceed to page 7.
Internal Mast Stem Cover Installed
Attaching Sirius to Internal Stem
Lift rotating handle from mast. Rotate Sirius mast until the bore holes for the locking
screws in the internal stem line up in the mast. Tighten locking screws into the mast
and internal stem to secure.
Note:
Do not use power drill. May cause damage to
umbrella. Once complete, proceed to “Leveling Umbrella” on page 7.
Bore Holes