Shademaker SR-27S, Owner'S Manual

Page: 10 / 12

2
9
I M P O R T A N T :
Please read this entire manual before installing or operating your Sirius umbrella.
S I R I U S W I N D R E S I S T A N C E G U I D E L I N E S :
Light to Moderate Winds (if used with mount kits)
When installed properly, the Sirius is engineered to handle light to moderate wind
conditions in the open canopy position. Please adhere to these wind guidelines:
1. If winds are present, the Sirius should be closed.
2. Do not keep the Sirius in a tilt position if you are experiencing windy conditions.
3. As winds get stronger or, in anticipation or uncertain/severe weather conditions,
the canopy should be lowered to the folded position and strapped to the mast.
4. The Sirius should always be left in the folded and strapped position when
unattended or not in use.
5. In anticipation of, and during extremely severe weather conditions, it is
advisable to remove and store the entire Sirius structure to protect it from
storm-related debris.
To Close Canopy
1. Pull slider car stop pin and turn counter clockwise to
vertical position so the slider car can move freely move
down mast. At the same time, guide slider car downward
with your other hand. Release slider car stop pin to lock in
place.
2. Insert crank handle into gear. Stand behind umbrella and
turn crank handle counter-clockwise canopy is lowered.
3. Strap canopy to the mast with supplied strap.
L I G H T A D A P T E R
To open light adapter:
Loosen light adapter built into the umbrella runner by turning
counter-clockwise. After loosening, pull down light adapter
post and attach umbrella light (sold separately).
To close light adapter:
Gently push up the light adapter post back into umbrella
runner and tighten turning clockwise
NOTE:
It is not
necessary to remove light to close umbrella.
To Rotate 360°
1. There are (8) 45° locking rotating positions. Raise the
turning handle above 90° and rotate mast to one of the
8 preset positions.
2. Lower handle to lock into place.
Open to the third position:
1. Repeat steps 1-3 outlined on previous page.
2. The canopy will now be in the Horizontal position.
HELPFUL HINT:
At any time, you may skip a position and open to the desired position
by turning the slider car stop pin parallel with the mast. In this position, the pin will NOT
auto locate as it passes over the predetermined holes. If you choose to pass the tilt
position(s) and go directly to the horizontal canopy position, you may move the pin into the
parallel position and continue winding, but be sure to turn the pin back to the horizontal
position before the horizontal canopy position is attained. If you pass the top hole, take the
tension out of the canopy and then pull the slider car stop pin down and into the top hole.