SGC Smartuner SG-211, Operating Manual

Page: 36 / 50

SG-211 User’s Manual
© 2004 SGC Inc. Page 34
5. Key the PTT switch on the microphone and
talk into the microphone. Notice that the
light turns on when you talk.
COUPLER TEST PROCEDURE
1. Connect the coupler to the radio.
2. Connect coupler light bulb load to Smartuner coupler
antenna out-put.
3. Turn on the radio and the Smartuner coupler.
4. Set the radio to the CW mode.
5. Key the PTT switch on the microphone and look at
the light bulb. The light should turn on if the coupler
has completed its’ tuning cycle and if the radio is
transmitting.
6. For further testing, follow steps 4 & 5 of the radio
test procedure. Note: The light bulb might not turn on
immediately if the coupler has not yet been tuned for
the frequency of the transmitter. The output power
(light-bulb brightness) is greatest when the coupler is
properly tuned. This test will ensure that the radio
and coupler are working properly.