![SG Models MASTER Edition ZERO KIT Assembly Manual Download Page 30](http://html1.mh-extra.com/html/sg-models/master-edition-zero-kit/master-edition-zero-kit_assembly-manual_1251001030.webp)
ZERO KIT
30
Instruction Manual.
3
.
- On the ire wall has the location for the throttle
pusshrod tube (pre-drill).
- Use a drill to drill the four holes in the engine
mount rails.
4
.
- Connect the Z-bend in the 450mm throttle push-
rod to the outer hole of the carburetor arm.
- Slide the throttle pushrod wire into the tube. Po-
sition the engine between the mounts. Use four
M4x30mm machine screws to secure the engine to
the mount as shown.
- Reinstall the servo horn by sliding the connec-
tor over the pushrod wire. Center the throttle stick
and trim and install the servo horn perpendicular
to the servo center line.
- Move the throttle stick to the closed position and
move the carburetor to closed. Use a 2.5mm hex
wrench to tighten the screw that secures the throt-
tle pushrod wire. Make sure to use threadlock on
the screw so it does not vibrate loose.
5
.
6
.
7
.
- Slide the pushrod tube in the iewall and guide it
through the fuel tank mount. Use medium C/A to
glue the tube to the iewall and the fuel tank mount.
Summary of Contents for MASTER Edition ZERO KIT
