SEW-Eurodrive MOVIFIT MC, Manual, Page: 24 / 32

6
Service
EBOX replacement
Manual – Functional Safety
24
6.2 EBOX replacement
Order If the EBOX is defective, order a new EBOX based on the EBOX type designation on
the nameplate of the complete MOVIFIT
®
device, see figure below.
Replace the EBOX as follows:
6.2.1 Open
When opening the device, adhere also to the safety notes in the "MOVIFIT
®
.." operat-
ing instructions. > Chapter "Central opening/closing mechanism".
1. Turn the central retaining screw in counterclockwise direction using a socket
wrench (SW8).
2. Remove the EBOX from the ABOX.
3. Check the type designation on the nameplate of the new EBOX.
ð In case of safety-related applications, the EBOX may only be replaced by a
new EBOX [2] with the same type designation as the EBOX type designation
on the nameplate of the complete MOVIFIT
®
device [1].
EBOX
MOVIFIT
®
DI03
DI01 DI02
DI00
DI04
DI05
DI06
DI07
DI08
DI09
DI1
1
DI12/DO00 DI13/DO01
DI14/DO02
DI15/Do03
SYS-F
BUS-F
24V
-C
24V
-S
RUN
RUN-PS
ABOX
=
!
[1]
[2]
D-76646 Bruchsal
MOVIFIT
Elektronikbox
Electr. box
Type:
15 13 15 11 12 – – – – 11 14 ML03
Eingang / Input
U
U
Ausgang / Output
= 3x380 . . . 500V AC = 3x0 . . . UN
T
Feldbus / Fieldbus:
P-Motor
PROFINET / Technology
= -25 . . . +40°C = 0,37kW / 0,5HP
f f = 50 . . . 60Hz = 2 . . . 120Hz
I I = 1,3A AC (400V) = 1,6A AC
SO#: 01.7729288913.0001.19
Made in Germany MOVIFIT
Type:
SO#:
MTM11A000-P10A-00
MTA11A-503-S523-00
01.177292889.0001.19
ML03
01
MTM11A000-P10A-00
IND. CONT. EQ.2D06
LISTED
®
MTM11A000-P10A-00 MTM11A000-P10A-00
30473017355
ð This ensures the FS 01 functionality after device replacement.
6.2.2 Close
When closing the device, adhere to the information in the "MOVIFIT
®
.." operating in-
structions. > Chapter "Central opening/closing mechanism" > "Closing".
1. Position the new EBOX on the ABOX.
2. Turn the retaining screw in clockwise direction (tightening torque maximum 7 Nm).
3. Supply the MOVIFIT
®
device with voltage.
29157056/EN – 09/2019