INTRODUCTION/QUICK START
Quick Start:
Connect the light blue coiled pump hose to the fitting label-
ed AIR OUT on the MP10. Connect the red (or black, depending on your
air source) air supply hose to a compressed air or gas source and con-
nect it to the fitting labeled AIR IN on the MP10. Supply up to 125 psi
compressed air or gas to the controller. Turn the controller throttle until
the gauge reads the approximate depth of the sample pump. Follow
instructions on the battery panel:
Opening the MP10 case turns power ON.
Select desired Cycles Per Minute (CPM) with (default value is 4
CPM, lower CPM for deeper wells, higher CPM possible with shallow
wells).
Turn throttle to set depth on gauge to 10-20 feet deeper than the pump
location in the well.
Cycle
I I
Press to START pumping.
When water discharge begins, adjust throttle until a slow, steady flow-
stream is achieved.
Press keys to set the desired purge flow rate.
To collect samples, continue purge flow, or use key to directly
control sample flow and pause.
5
