Servomex DF-130E, Operator'S Manual

Page: 15 / 88

Analyzer Start-Up Procedure DF-150E 11
5 Analyzer Start-Up Procedure
Your analyzer has been thoroughly tested and calibrated however, it is
necessary to make proper gas connections and to “charge” the sensor prior to
turning the analyzer on.
Analyzer start-up requires the following procedures:
A. Charging the Sensor
B. Making Sample Gas Connections
C. Making Output Signal Connections
D. Powering up the Analyzer
CAUTION
To avoid damage to your analyzer:
 Do not operate without electrolyte
 Do not use more than one bottle of E -Lectrolyte Blue
 Do not operate without gas flow
 Do not operate a trace level analyzer for more than a few
minutes while exposed to air.
 Do not exceed the pressure and flow limits
The electrolyte is a caustic solution. Review the Material
Safety Data Sheet (MSDS) on page 71 before handling the
electrolyte solution.