16
Parts and features
This manual covers different stove models. Your stove might not include some parts and features detailed as follows:
COIL ELEMENTS/HOT PLATES
OVEN LIGHT SWITCH
(SOME MODELS)
OVEN SAFETY LIGHT (30" MODELS)
GENERAL SAFETY LIGHT (20" MODELS)
OVEN KNOB
COOKTOP
COOKTOP INDICATOR LIGHT (30"
MODELS)
CONTROL PANEL
LOWER DRAWER (SOME MODELS)
Installation Instructions
Make sure your stove is appropriately installed and connected to ground by a qualified technician.
To reduce risk of fire, avoid placing kitchen furniture over the stove as its inferior surfaces' overheating might cause flame.
Another way to reduce this risk is by installing a grease extractor under the kitchen furniture. This extractor should overhang
at least 13 cms. out of the border.
WARNING
Review the stove location. Verify if there is an appropriate power source and the floor is well levelled. Make sure the walls or surfaces around the
stove are resistant to the heat produced by the stove.
The following diagram shows the minimum required separation. Check that contact
surfaces are solid and levelled. Adjust the two rear leveller screws with a key to
secure higher stability of the stove.
"A" = The minimum separation between the stove plate and the metal or non
protected wood kitchen furniture inferior part should be 75 cms. The minimum
separation between the stove plate and the protected kitchen furniture inferior
part must be 60 cms.
"B" = This dimension will depend on the model width: 51 cms. if this is a 20
inches stove or 76 cms. if it is a 30 inches stove.
To protect the inferior part of a kitchen furniture, a fire retarding briquette sheet no
less than 6.5 cms. thick must be placed or a #28 steel sheet, a 0.5 mm thick
stainless steel sheet or a 0.6 mm. thick aluminium sheet.
LOCATION
Make sure the oven is turned off and cold before replacing the oven light bulb.
CAUTION
OVEN SAFETY LIGHT
Some of our models are equipped with a luminous indicator for the Cook Top that turns on when the oven is in use.
GENERAL SAFETY LIGHT
Some of our models are equipped with a general luminous indicator that will turn on when some disk or the oven are working.
OVEN SAFETY LIGHT
Some of our models are equipped with a luminous indicator for the oven that turns on when the oven is in use.
Replacing the oven light bulb:
1. Disconnect the stove from the plug.
2. Use a leather glove as a protection against possible light bulb breaking.
3. Replace the light bulb by a new one with the same voltage and power conditions.
OVEN LIGHT SWITCH
Some of our models are equipped with an oven light. To turn the oven light on, the switch in the control panel must be turned on.
ELECTRONIC CLOCK/TIMER (SOME MODELS)