www.SereneLifeHome.com
10
STORAGE
Store the treadmill in a clean and dry indoor environment. Never leave or use the unit outdoors. Ensure the
master power switch is off and the power cord is un-plugged from wall outlet.
TROUBLESHOOTING GUIDE
LUBRICATION
Lubricating under the running belt will ensure superior performance and extend its life expectancy. After
the first 25 hours of use (or 2-3 months) apply some lubricant, and repeat for every following 50 hours of use
(or 5-8 months).
How to check running belt for proper lubrication
•
Lift one side of the running belt and feel the top surface of the running deck.
•
If the surface is slick to the touch, then no further lubrication is required.
•
If the surface is dry to the touch, apply some lubricant.
How to apply lubricant
•
Lift one side of running belt.
•
Pour some lubricant under the
centre
of the running belt on the top surface of the
running deck.
Run on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
NOTE:
DO NOT over lubricate running deck. Any excess lubricant that comes out should be wiped off.
Problem
Potential Causes
Corrections
Tr ead mill will no t
start .
1. Treadmill n ot plugged in.
2. Safety Tether Key is not
co rrectly installed.
3. Circuit breaker in the
ho use has been tripped.
4. Treadmill circuit breaker
ha s been tripped.
1. Plug the power cord into a wall
ou tlet.
2. Reinstall the Safety Tether Key.
3. Reset the circuit breaker, or call
an electrician to replace the
circuit breaker.
4. Wait 5 minutes and then try to
re start the treadmill.
Belt slips.
Belt not tight enough.
Adjust belt tension.
Belt hesitates when
stepped on.
1. Not enough lubrication
applied on to the running
deck.
2. Belt is too tight.
1. Apply lubricant.
2. Adjust belt tension.
Belt is not centred.
Runn ing belt tension not even
across the rear roller.
Centre the belt.
Lubricant
1 PC
