Sercomm DBC831V2, Setup Manual, Page: 15 / 22

13
Power Kit Installation
The Power Kit included with the doorbell camera is a small device, which support Doorbell
with any kinds of analog and digital chime usage by going between the doorbell transformers
and chime wiring.
Note : Before removing or attaching wires to your original bell, be sure that the power is turned
off at the breaker box. Consult a licensed electrician if needed.
1. Turn off the circuit breaker for the indoor chimer.
2. Remove the cover from the indoor chimer.
3. Loosen the "Front" and "Trans" terminal screws on the indoor chimer.
4. Connect white wire from the Power Kit to the “Front” terminal, and the black wire to the
“Trans” terminal, leaving the existing doorbell wires in place. Then, re-tighten the screws.
5. Position the Power Kit inside your indoor chimer, away from any moving parts. Use the
adhesive (foam tap) on the back of the Power Kit to fix it in place, if desired.
6. Attach the cover back to the indoor chimer, and turn the power on at the breaker.