TubTop™
Sequoia Spa Shelters™ by Sequoiaworks Inc.
Co
rn
er
p
an
el
If using a Cover Valet cover li (op onal):
Some installa ons require a filler strip to wid-
en the shelf. The purpose of the filler strip is
to close the space between the shelf rail and
the spa lip. It is also required for installing a
“deck mounted” cover li device.
Fasten the filler strips to the side of the shelf
rails using 2 1/2 inch screws. Locate the filler
strip 4 inches from the front end of the shelf
rail. This will put the filler strip even with the
edge of the spa. The length of the filler strip is
the same as the dimension of the spa.
4”
With the shelves temporarily fastened to the a achment brackets, the four
walls are then posi oned and secured on to the shelves. Begin with the side
opposite the spa control side. This is typically the solid wall (no opening).
First connect corner panels at both ends of the wall as shown below.
Fille
r st
ri
p
Space at bo om end of
corner panel
Posi on the corner panel against the end of the wall
panel. (The angled frame at the top of the wall panel
overlaps the frame of the corner panel.)
Fasten the corner panel to the wall panel using a #8 x 3
inch wood screw downward into the top end of the
corner panel frame.
Fasten the wall panel and the corner panel together
down the side of the frame using three #8 x 2 ½ inch
wood screws.
#8 x 2 ½ inch screws
#8 x 3 inch screw
