Sentryus HD-NVR Series, User Manual

Page: 107 / 163

User Manual of Network Video Recorder
106
10.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the General tab.
Figure 10. 1 Network Settings Interface
3. In the General Settings interface, you can configure the following settings: Working Mode, NIC Type, IPv4
Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP address
and other network settings from that server.

For the models which have the PoE or built-in switch network interfaces, the internal NIC IPv4 address
should be configured for the cameras connecting to the PoE or built-in switch network interface of
the NVR.

The valid value range of MTU is 500 ~ 9676.
4. After having configured the general settings, click Apply button to save the settings.
10.2 Configuring Advanced Settings
10.2.1 PPPoE Settings
Purpose:
Your NVR also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the PPPoE tab to enter the PPPoE Settings interface, as shown in Figure 10. 2.