Copyright © 2010. All rights reserved.
2
REV122010-V28
www.SentryUS.com
2. Hold Back Function – Always Unlocked with Non-Latching
Turn the inside handle down from 3 o’clock position to 6 o’clock position. Then slide
the latch stopper from right to left to keep the hand down.
*A door closure is recommended.
v
3. Disable Code Function – Night Latch
This function is enabled as factory
default. If your door is right hand, turn the
inside handle to 12 o’clock position and
slide the latch stopper from left to right to
keep the hand up (see fig. 5).
To disable function, screw the BLACK
handling screw to the right hole as seen
in fig. 6.
Changing the Code
The Factory Default code is 13579. Slide the code pin from the NON CODE position to
CODE position and the code number will be the new code number. The CLEAR button
MUST ALWAYS be used as the first digit of a code. For security reasons, the code must
be more than 4 digits. Check to see if the new code works before installation.
Note: Entering the code in any sequence will open the door. i.e. 13579 or 97351.
Fig. 5
Fig. 6
