ECO: 102-0461-01
S-4014
Rev B
20
∆
WARNING
BEFORE YOU ENTER A HAZARDOUS ATMOSPHERE WEARING THIS
RESPIRATOR SYSTEM, YOU MUST INSPECT THE RESPIRATOR
SYSTEM, COMPLETE AN AIRFLOW CHECK, AND DON THE SYSTEM
ACCORDING TO THE INSTRUCTIONS IN THIS MANUAL. FAILURE
TO DO SO MAY ADVERSELY AFFECT RESPIRATOR PERFORMANCE
AND MAY RESULT IN INJURY OR DEATH.
DO NOT WEAR THIS RESPIRATOR SYSTEM TO ENTER AREAS
WHERE ATMOSPHERIC CONCENTRATIONS OF CONTAMINANTS
ARE UNKNOWN. AREA MAY EXCEED THE MAXIMUM USE
CONCENTRATION (MUC) FOR THE RESPIRATOR HOOD, OR
ATMOSPHERE MAY CONTAIN LESS THAN 19.5% OXYGEN. THIS
MAY RESULT IN IMMEDIATE DANGER TO PERSONNEL.
∆
WARNING
ALWAYS DON THE RESPIRATOR IN A NON-CONTAMINATED AREA.
FAILURE TO PROPERLY DON THIS RESPIRATOR BEFORE
ENTERING A HAZARDOUS ATMOSPHERE MAY RESULT IN INJURY
OR DEATH.
∆
WARNING
IF YOU HAVE ANY DOUBTS ABOUT THE APPLICABILITY OF THE
EQUIPMENT TO YOUR JOB SITUATION, CONSULT AN INDUSTRIAL
HYGIENIST OR CALL THE TECHNICAL SERVICE DEPARTMENT OF
ILC DOVER AT (800) 631-9567.
DO NOT REACH YOUR HAND INTO THE HOOD IN AREAS WHERE
THE AIR IS CONTAMINATED. LEAVE THE CONTAMINATED AREA
AND CLEAN CONTAMINANTS FROM YOUR HANDS BEFORE
REACHING INSIDE THE HOOD.
12. Donning the Hood with a Two-Suit Configuration
Don the blower and hood in a safe hazard-free area and accomplish the following:
•
Adjust the blower and belt on your waist. Adjust the belt for a comfortable fit -
keeping the breathing hose and hood behind the head and shoulders.
•
Switch the blower
ON
.
•
Check that the cartridges are properly mounted on the blower unit before
donning the hood.
•
With the help of another person complete the donning sequence as shown
below.
