PAGE 29
after 6 rings from a remote telephone.
1. Press
2. Enter Alternate Prefix Mode
00
= To enter Direct Commands use "##"; Programming use "
"
01
= To enter Direct Commands use a combination of 2 keys (i.e. "#
" or "
#");
Programming use a combination of three keys (i.e. "#
#" or "
#
")
02
= To enter Direct Commands use "
"; Programming use "
"
03
= To enter Direct Commands use "##; Programming use "##"
04
= Resident will NOT be able to program from their telephone or use Direct Commands
1[N] = To enter Direct Commands use "[N]#"; Programming use "[N][N]
".
([N] = Any number (1-9) on the telephone keypad.)
3. Press
Sets the Alternate Prefix to enter Direct Commands to "#
" or "
#"; and Programming to "#
#" or "
#
".
EXAMPLE:
2
1
3
1. Press
2. Enter Number of Rings (1-19)
3. Press
Rings Before Answer - 29
Other System Settings
1. Press
2. Enter No-Telco Mode (1-digit)
0 = Disables
No-Telco
Mode
1 = Enables
No-Telco
Mode
3. Press
Enable/Disable the No-Telco Mode- 33
Enables No-Telco Mode
EXAMPLE:
2
1
3
1. Press
2. Enter Delay Time (1-99 seconds)
3. Press
Override Telephone Company Answering Service- 43
Sets the answering service delay to 15 seconds.
EXAMPLE:
2
1
3
Sets the number of rings before the Crown Jewel will answer a call from a remote telephone. If you have an answering
machine (or answering service) attached to the same telephone line as the unit, set the Crown Jewel count for two (2) or
more rings higher than the answering machine/service count.
FACTORY SETTING:
5 Rings
The Crown Jewel unit will answer the call
after 6 rings from a remote telephone.
EXAMPLE:
2
1
3
Set Alternate Prefix - 36
When you press either “##” or “QQQ” on the resident phone, the Crown Jewel will look for Direct Commands or
Programming and it disconnects the phone line and waits for a command. Some Telephone companies require “#” and
“
✱
”.
FACTORY SETTING:
00 (“##” = Direct Commands; “
✱✱✱
= Programming).
No-Telco mode is used when a unit is NOT using a phone line. After enabling the “No-Telco” mode, Step #32 -”Reset the
Unit” MUST be performed.
FACTORY SETTING:
0 (Disabled)
To override the answering service, dial the number attached to your unit, let the phone line ring once or twice and
disconnect the call. After a few seconds redial. The Crown Jewel will answer immediately.
FACTORY SETTING:
20 seconds
