PAGE 27
Programming Multiple Units
2. Press
. The unit will beep twice again.
1. Dial the residence telephone number
When the Crown Jewel picks up the call, the unit will beep twice.
6. Press
. The tone will stop and the Crown Jewel unit is ready for programming
4. Enter Unit ID Code (1-7)
5. Enter Unit Password (6-digits). The unit will emit a high-pitched tone
3. Press
Enters unit #1 into programming mode. Unit #1 is now ready to receive programming input.
EXAMPLE:
1
2
5
4
3
6
Using a Remote Telephone
1. Press
on the resident phone
4. Press
. The tone will stop and the Crown Jewel unit is ready for programming
2. Enter Unit ID Code (1-7)
3. Enter Unit Password (6-digits). The unit will emit a high-pitched tone
Enters unit #2 into programming mode. Unit #2 is now ready to receive programming input.
EXAMPLE:
3
4
2
1
Using the Resident’s Telephone
Multiple Unit Installations
Up to seven (7) Crown Jewels can be installed on a single telephone line. Each unit must have a unique number from 1-7. Visitor
calls can only be taken one at a time. For example: if you take a visitor call from the main gate (unit #1) and a visitor attempts to
call from a rear gate (unit #2), you will not be notified until the first call is disconnected. However, if you are making a regular
phone call, the call waiting feature will operate normally.
When you program the Crown Jewel from the residence telephone or a remote telephone, you MUST include the unit ID
code.
IMPORTANT NOTES:
If you make an error during an entry, press the asterisk key (
✱
) to begin again.
The pound key (#) MUST be used to SAVE the data at the end of each programming step.
Time MUST be entered using a 24-Hour format (8:00 AM = 0800, 3:00 PM = 1500 etc.)
2 Short Beeps: Programming input is valid 1 Long Beep: Input is not valid.
